An affordable connectivity solution, Quick Disconnect simplifies wiring and expedites the installation and replacement of sensors – making it easy to remove sensors for cleaning or replace a damaged unit without the need for a licensed electrician. Available in either the M12 Eurofast or 7/8” Minifast sizes, Quick Disconnect consist of male and female connectors–purchased separately. The male connector is installed in the sensor’s conduit opening and pre-wired to the control board. Once installed, the sensor can be easily removed by disconnecting it from the field-wireable straight female connector.
Quick Disconnect can be used with most BinMaster point level sensors including rotaries, vibrating rods, capacitance probes, and tilt switches. They can also be used with BinMaster’s flow detection sensor. By adding a T connector, Quick Disconnect works in a daisy-chain of NCR-80 Non-Contact Radars using the Modbus protocol.
Item Code | Description |
BC-530-0871 | M12 Eurofast male quick disconnect connection installed into the senors conduit and pre-wired to the control board |
BC-530-0872 | 7/8” Minifast male quick disconnect connection installed into the senors conduit and pre-wired to the control board |
BC-318-0236 | Field-wireable M12 Eurofast straight female connector, plastic (PBT Or Nylon) |
BC-318-0237 | Field-wireable 7/8” minifast straight female connector, glass-filled nylon body |
BC-398-0585 | 4/18 AWG YELLOW PVC; bulk cable, coil, with yellow polyvinyl chloride outer jacket, wire complement: altogether 4X18 AWG wires. Non-returnable. Sold by the foot. |